Rockler 4-Pc. Straight Bit Set

Set includes four carbide-tipped, 2-fluted bits:

1/4" x 1" (#90385).
3/8" x 1" (#90462).
1/2" x 1" (#90550).
3/4" x 1" (#90638).
Measurements are diameter x length.
All bits have 1/2" shanks to reduce chatter and provide maximum performance.

Rockler Router Bits are the finest available for use in creating jewelry boxes, humidors, and other small boxes and crafts!

Top quality bits that meet the high demands of Rockler Woodworking and Hardware. A fantastic value on high quality router bits. These bits are competitively priced while offering high performance and long life.

Quality performance features include:

K10 and K20 grade carbide for clean cutting action.
final sharpening with 600 - 800 grit diamond wheels.
Precision balanced for smooth operation.

If you are not 100% satisfied with these bits, send them back for a refund.

Router Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.

1) Rockler recommends using 1/2" shank router bits whenever possible. 1/2" shanks provide better stability with less vibration to produce a smoother cut and longer cutter life.
2) Make multiple light passes rather than one heavy cut.
3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch.
4) Use a router table whenever possible.
5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber.
6) Always follow your router manufacturer's recommendations.